Loading...
3 results
Search Results
Now showing 1 - 3 of 3
- Densification and heat treatment of maritime pine woodPublication . Esteves, Bruno; Ribeiro, Fábio; Cruz-Lopes, Luísa; Ferreira, José; Domingos, Idalina; Duarte, Marta; Duarte, Sónia; Nunes, LinaPine (Pinus pinaster Ait.) wood samples were subjected to a combined treatment by densification and heat treatment. Samples were densified before and after heat treatment. The heat treatment was made inside an oven at 190ºC during 2 to 6 h and wood densification was made in a hot press at around 48 bar pressure and temperatures between 160ºC and 200ºC for 30 min. Compression-set, compression-set recovery after three cycles of water soaking followed by oven drying, density, hardness, bending strength and stiffness and durability against subterranean termites were determined after the treatment. Results show that densification increases density, hardness, bending strength, stiffness and durability against termites. Heat treatment applied after the densification is more effective in reducing compression-set recovery than if applied before.
- Optimizing Douglas-fir bark liquefaction in mixtures of glycerol and polyethylene glycol and KOHPublication . Esteves, Bruno; Cruz-Lopes, Luísa; Ferreira, José; Domingos, Idalina; Nunes, Lina; Pereira, HelenaThe outer bark of Douglas-fir (Pseudotsuga menziesii) has a significant amount of cork tissue that may be an important source of chemicals derived from its natural polymers, suberin, cellulose, hemicelluloses and lignin. The present work focuses on the polyalcohol liquefaction of Douglas-fir bark with glycerol and polyethylene glycol (PEG) in order to obtain a liquid that can be further processed to other chemicals and products. The results show that Pseudotsuga bark can be liquefied in a significant percentage in presence of alkali. The best liquefaction yield was obtained with 6% KOH as agents. Although the use of a cosolvent is favorable, good liquefaction yields can also be obtained by glycerol alone. Lower temperatures are favorable as they lead to acceptable liquefaction yields. FTIR-ATR studies showed that all the structural compounds of the bark were attacked and depolymerized. The process tested has a high potential for generation of value-added products from liquefied Douglas-fir bark.
- Artificial Weathering of Heat-treated Pines from the Iberian PeninsulaPublication . Esteves, Bruno; Herrera, René; Santos, Jorge; Carvalho, Luisa; Nunes, Lina; Ferreira, José; Domingos, Idalina; Cruz-Lopes, LuísaSamples from the two most common pines grown in Portugal (Pinus pinaster Ait) and Spain (Pinus radiata, D. Don) were heat-treated in industrial facilities in accordance with ThermoWood ® class D. For both species, the variation in surface properties, of untreated and heat-treated wood after artificial weathering from 75 to 750 h, is presented. The analysis included the determination of color, roughness, gloss, and wettability before exposure and after each artificial weathering period. Untreated woods became darker faster, while in heat-treated woods, lightness remained approximately constant until 750 h of artificial weathering. Both untreated and heat-treated wood became more reddish in the beginning of the weathering process, turning greener for longer exposure times. Untreated woods became yellower in the beginning, turning into blueish tones later. Heat-treated wood turned slightly yellower until 750 h of weathering. Gloss decreased for untreated wood with no significant changes in heat-treated wood. Despite the changes, the gloss of both untreated and heat-treated wood converged to similar values. Roughness increased for both untreated and heat-treated woods. Artificial weathering increased the wettability of heat-treated wood.